SAM 440EP No sound

This forum is for all AmigaOne 500, Sam440 and Sam460 specific issues.

SAM 440EP No sound

Postby Mikey_C » Thu Apr 10, 2014 12:01 am

Hi all

I have been unable to enjoy the use of my Amiga since november, basically, I got a SAM 440 EP and passed on my MicroA1 for free, however, it turned out that the SAM440EP has no sound, it appears to be a hardware issue. This I confirmed because we created (ANT) a bootable SAM440EP AmigaOS4 Disc and then just booted into the disc, tried the sound,nothing happened. We put the exact same disc into another SAM440EP and there was Sound.

I contacted ACUBE but apart have not heard back from them in over a month regarding my problem, after a couple of initial email exchanges, I was looking to see if the board could be checked by them and if so, maybe possibly repaired.

So, I am currently Amiga less, I would like to get back to the Amiga community, but without an Amiga it is currently impossible, does anyone here have any ideas please?

Cheers

MIkey C
Mikey_C
 
Posts: 23
Joined: Mon Oct 10, 2011 7:38 pm

Re: SAM 440EP No sound

Postby tonyw » Thu Apr 10, 2014 12:35 am

This is a well-known issue, caused by a bad update last year. The file "Devs/AHI/CS4281.device" V5.6 (12/05/2013) is bad and prevents audio from working.

Once you revert to V5.5 (26.07.2009), your audio will all be sweet. You can use AmiUpdate to revert or just copy it from your install CD.
cheers
tony
User avatar
tonyw
AmigaOS Core Developer
AmigaOS Core Developer
 
Posts: 1312
Joined: Wed Mar 09, 2011 2:36 pm
Location: Sydney, Australia

Re: SAM 440EP No sound

Postby Mikey_C » Thu Apr 10, 2014 11:11 pm

aha! But alas I have got CS4281.device" V5.5 installed and I still have no sound.

I hope someone here will be able to help, I really do, I want to get back to the Amiga experience :-(
Mikey_C
 
Posts: 23
Joined: Mon Oct 10, 2011 7:38 pm

Re: SAM 440EP No sound

Postby cha05e90 » Fri Apr 11, 2014 11:01 am

You might check whether all (!) units in AHI prefs are muted or not. This was the case when I switched my Sam440ep on for the first time. Back then it seemed to be a (wrong) default setting.
X1000|II/G4|440ep|2000/060|2000/040|1000
User avatar
cha05e90
 
Posts: 86
Joined: Fri Jun 17, 2011 11:15 pm
Location: Germany

Re: SAM 440EP No sound

Postby Mikey_C » Fri Apr 11, 2014 4:48 pm

They are not, in addition, when I plug in a jack into the headphone socket at the rear the speakers do not so much as crackle.

Anyone got any other ideas?

I personally think its hardware, but as I said, Acube haven't replied to my last email and I know they got it. :-(
Mikey_C
 
Posts: 23
Joined: Mon Oct 10, 2011 7:38 pm

Re: SAM 440EP No sound

Postby tonyw » Sat Apr 12, 2014 1:20 am

Surely sounds like hardware. You could try another power supply (the Sam may depend on a PSU output that nothing else does), but otherwise, it sounds like a "go home to Mother" job.
cheers
tony
User avatar
tonyw
AmigaOS Core Developer
AmigaOS Core Developer
 
Posts: 1312
Joined: Wed Mar 09, 2011 2:36 pm
Location: Sydney, Australia

Re: SAM 440EP No sound

Postby nbache » Sat Apr 12, 2014 11:48 pm

Mikey_C wrote:They are not, in addition, when I plug in a jack into the headphone socket at the rear the speakers do not so much as crackle.
Just to make sure: If you pull out the jack again and touch the tip of it with a finger, do your speakers hum? If not, the problem is probably in your audio chain rather than in the Sam (and vice versa).

Best regards,

Niels
User avatar
nbache
Beta Tester
Beta Tester
 
Posts: 1267
Joined: Mon Dec 20, 2010 8:25 pm
Location: Copenhagen, Denmark

Re: SAM 440EP No sound

Postby LyleHaze » Sun Apr 13, 2014 12:35 am

I'm not sure how the SAM440 sound is wired ionto the case, but I learned a few things when working my way through HDAudio that might apply:

There are two separate ways to wire a case for audio. One is AC97 and the other is HDAudio.. these two are NOT compatible.

If the SAM440 has an AC-97 header on board, the sound jacks on the back may not work unless the header to the front audio ports is connected properly, AND the actual jacks in the case are OK too.

Please read that last line again.. EVEN the BUILT IN jacks on the back will fail if the front panel stuff is not connected properly. This could possibly include plugging an HDAudio case harness into an AC-97 header.

It all comes down to the audio path in hardware. On the older AC-97 system, the left and right outputs are wired through the board header and the case wiring harness to the front headphone jack.. in addition to the headphone connections are a couple "normally closed" contacts that carry the signal BACK to the board header, where it is passed on to the rear jacks. When it works correctly, plugging in headphones would mute the rear outputs.

Obviously the long signal path and variety of connections points is less than ideal.

On HDAudio boards/cases, the sound card has separate outputs for front and rear audio, and instead of switching audio at the front headphone jacks, there is a simple one bit return indicating whether anything is plugged in or not. So the Audio switching is now done in software which is a lot less likely to cause problems.

So, if this board has never worked in this case, you might want to check the wiring harness in the case for a label, either AC97 or HDAudio, and check the Sam documentation as well.

Good Luck,
LyleHaze
User avatar
LyleHaze
AmigaOS Core Developer
AmigaOS Core Developer
 
Posts: 511
Joined: Sat Jun 18, 2011 5:06 pm
Location: Georgia, USA, just North of the Florida border

Re: SAM 440EP No sound

Postby tonyw » Sun Apr 13, 2014 5:07 am

@LyleHaze:

The Sam440ep has only a single ring-tip-sleeve jack on the motherboard. The on-board audio is a CS4281 with a RealTek ALC655 codec.
There is a 22-way "Audio Expansion" connector, but I doubt that Mikey has it wired to anything.
cheers
tony
User avatar
tonyw
AmigaOS Core Developer
AmigaOS Core Developer
 
Posts: 1312
Joined: Wed Mar 09, 2011 2:36 pm
Location: Sydney, Australia

Re: SAM 440EP No sound

Postby Mikey_C » Sun Apr 13, 2014 12:25 pm

Tony is correct, I have not got the motherboard wired to anything. I have photos of the thing, but stick them where?
Mikey_C
 
Posts: 23
Joined: Mon Oct 10, 2011 7:38 pm

Next

Return to Platform: AmigaOne 500 and Sam series

Who is online

Users browsing this forum: No registered users and 5 guests

cron