Uboot
Posted: Thu May 18, 2017 2:28 am
Having used CFE on my X1000 for a few years, I've forgotten what Uboot is supposed to tell me. I always get the following when booting my revamped SAM460ex:
------------------------------------
Config: PCIe 4x + PCIe 1x
USB: scanning bus for devices ... 6 USB Device(s) found
scanning bus for storage devices... 2 Storage Device(s) found
SATA Device 0: OK SATA Device 1: not available SATA Device 2: ..........
Model: ATAPI Firm: ALa5 Ser#: iHAS24 B
Type: Removeable CD ROM
Capacity: 538.8 MB = 0.5 GB (275878 x 2048)
not available
Press SPACE for prefs, ENTER for boot select, ESC for prompt
Booting... 4
---------------------------------------
So, is that "ATAPI ... CD ROM" SATA Device 2? How does Uboot know so much about a device that isn't available?
More to the point, can I set something in Uboot that will save me from waiting for it to give up on that ".........." stuff?
------------------------------------
Config: PCIe 4x + PCIe 1x
USB: scanning bus for devices ... 6 USB Device(s) found
scanning bus for storage devices... 2 Storage Device(s) found
SATA Device 0: OK SATA Device 1: not available SATA Device 2: ..........
Model: ATAPI Firm: ALa5 Ser#: iHAS24 B
Type: Removeable CD ROM
Capacity: 538.8 MB = 0.5 GB (275878 x 2048)
not available
Press SPACE for prefs, ENTER for boot select, ESC for prompt
Booting... 4
---------------------------------------
So, is that "ATAPI ... CD ROM" SATA Device 2? How does Uboot know so much about a device that isn't available?
More to the point, can I set something in Uboot that will save me from waiting for it to give up on that ".........." stuff?