ColumnInfo Height
Posted: Fri Apr 01, 2016 3:40 am
When showing varying image sizes in a listbrowser (with a ColumnInfo used) each row can be of different heights depending on the image. You can set a width, but not height.
Could LBCIA_Height be added to force every row to be the same size?
This way images smaller than the max sizes specified would be vertically and horizontally centered and every row is the same height. Not some rows 64 tall, some 24 tall, some 50 tall, etc.
With text, some rows may have only 1 line, others may have 5. Normally you wouldn't need to set a height for that, but maybe you would if you needed/wanted a consistent look.
Would also be easier to figure out max lines shown since there would be no variation.
By default it would not be specified/enabled.
LBNCA_VertJustify would be needed then, too. TOP, MIDDLE/CENTER, BOTTOM.
Could LBCIA_Height be added to force every row to be the same size?
This way images smaller than the max sizes specified would be vertically and horizontally centered and every row is the same height. Not some rows 64 tall, some 24 tall, some 50 tall, etc.
With text, some rows may have only 1 line, others may have 5. Normally you wouldn't need to set a height for that, but maybe you would if you needed/wanted a consistent look.
Would also be easier to figure out max lines shown since there would be no variation.
By default it would not be specified/enabled.
LBNCA_VertJustify would be needed then, too. TOP, MIDDLE/CENTER, BOTTOM.